Installing Drivers And Software; Installing The Intel Raid Controller Software; Installing The Optional Burner Or Dvd Software - Siemens SIMATIC HMI IPC677C Operating Instructions Manual

Service and maintenance
11.9 Reinstalling the software
11.9.6

Installing drivers and software

Introduction
Note
In the case of multilingual operating systems (MUI versions), you have to set the regional
settings for menus and dialogs and the default language to English (US) before you install
new drivers or operating system updates.
Procedure
To install the drivers and software from the supplied "Documentation and Drivers" CD/DVD,
proceed as follows:
1. If your device has no CD/DVD drive, connect an external USB CD/DVD drive to a USB
2. Insert the DVD.
3. Start the "START" program.
4. Select "Drivers & Updates" from the index.
5. Select the device and operating system.
6. Select the desired driver.
7. Open the folder with the driver data by clicking on the link next to "Driverpath".
8. Start the setup program in this folder.
Note
For a new installation of Windows operating systems, the chipset driver must be installed
before all other drivers, if required.
11.9.7

Installing the Intel RAID controller software

The software installation of the onboard RAID controller takes place with its driver
installation. Additional information on this is available in the section "Installation of drivers
and software".
11.9.8

Installing the optional burner or DVD software

Information about installation of the burner / DVD software is available on the supplied CD.
158
port.
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04