Mounting Positions And Fastening; Installation Guidelines - Siemens SIMATIC HMI IPC677C Operating Instructions Manual

Planning the use

3.4 Mounting positions and fastening

3.4 Mounting positions and fastening
3.4.1

Installation guidelines

Before installing the device, read the following general notes relating to installation.
Danger, high voltage
Isolate the power supply to the switchgear cabinet before opening it. Ensure that the power
to the switchgear cabinet cannot be turned on accidentally.
NOTICE
Operation only in closed rooms
The device is approved for operation in closed rooms only.
● Ensure that the protective contact socket of the building installation is easily accessible
● Position the screen in an ergonomic position favorable to the user. Choose a suitable
● Position the screen so that it is not subject to direct sunlight or other strong sources of
● Optical drives are susceptible to shock. Shocks during operation can lead to the loss of
● Applies to devices which are installed in swivel arm housings: Avoid rapid or jerky
● Applies to devices which are installed in cabinet doors: Prevent the doors being slammed
● The device has to be installed in the mounting cutout of a housing that fulfills the
28
WARNING
and that there is a mains disconnect switch in switchgear cabinet installations.
installation height.
light.
data or damage to the drive or data carrier. Optical drives are not only suitable for
continuous operation.
movements of the swivel arm during operation. The ensuing forces could lead to possible
irreversible damage to the hard disk.
The stops of the swivel arm must be damped in order to avoid a harsh impact to the
Panel PC generating a mechanical shock effect to the device.
shut. The ensuing forces could lead to possible irreversible damage of the hard disk.
requirements of IEC/EN/DIN EN 60950-1, Chapters 4.6 and 4.7.3.
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04