Operating the device
5.3 Operating RAID systems
5.3
Operating RAID systems
5.3.1
Manage onboard RAID system
The RAID system of the manufacturer can also be used via the motherboard. The BIOS
setup is used to set up this system. Additional information is available in the sections "RAID
systems (Page 42)" and "Replacing a defective hard disk drive in the RAID system
(Page 70)".
Note
The key combination <CTRL+I> is only effective in "Legacy" mode. If the "Boot Type"
parameter is set to "UEFI Boot Type in the "Boot" menu in the BIOS setup, the RAID
hardware is configured by using the "Device Management" button in the BIOS selection
menu.
5.3.1.1
Example for a RAID1 system during the boot phase of the system
46
Operating Instructions, 07/2019, A5E45118479-AB
SIMATIC IPC1047