Data Backup / Subsequent Modification Of Partitions; Hardware Supported; Creating An Image; Modifying The Partitions - Siemens Simatic IPC647C Operating Instructions Manual

11.2.10

Data backup / subsequent modification of partitions

11.2.10.1

Hardware supported

Note
Older versions of the SIMATIC IPC Image Creator do not support the hardware of the
SIMATIC IPC647C.
Support is available as of SIMATIC IPC Image & Partition Creator Version 3.1.
11.2.10.2

Creating an image

Data backup under Windows XP Embedded / Windows XP Professional / Windows 7 Ultimate
To back up data under Windows XP Embedded / Windows XP Professional /
Windows 7 Ultimate, we recommend the software tool "SIMATIC IPC Image & Partition
Creator". This tool provides comfortable and efficient functions for backup and restoring the
full content of Compact Flash cards, HDDs and individual partitions (images.)
The "SIMATIC IPC Image & Partition Creator" only supports burning to DVD media.
The software can be ordered from the Siemens online ordering system. For detailed
information about "SIMATIC IPC Image & Partition Creator", please refer to the
corresponding product documentation.
11.2.10.3

Modifying the partitions

In order to modify partitions, we recommend using the software tool
"SIMATIC IPC Image & Partition Creator".
Detailed information about using this tool is available in the manufacturer documentation of
the "SIMATIC IPC Image & Partition Creator".
11.2.11

CP 1616 onboard

NDIS device driver
Read the information in the description Installation_CP16xx.pdf document on the supplied
Documentation and Drivers CD.
PROFINET IO
Please note the information on the SIMATIC devices and SIMATIC NET documentation
listed in
SIMATIC IPC647C
Operating Instructions, 12/2010, A5E02669337-02
I ntegration into an automation system (Page
7
Service and maintenance
11.2 Reinstalling the software
5 5).
3
119