Operation and configuration
8.3 Additional drivers and applications
8.3.1
Standard calibration procedure
Procedure
1. Select "Start > Programs > UPDD > Settings".
2. Select the Controller
3. Click on the "Calibration" tab
4. Activate the option box "Number of points" with the 25 points calibration
5. Click the button "Calibrate"
6. Touch the corresponding selections one after the other.
7. Confirm all input prompts (arrows, or crosses in the center) until the complete screen has
8. Finally, confirm the input prompt "Confirm".
82
The dialog box "UPDD Console" opens.
Figure 8-1
Standard calibration
①
The calibration screen is displayed in the selected display.
The entry is confirmed by a check mark, the next selection is displayed.
been calibrated.
you wish to calibrate.
②
.
④
.
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04
③
.