Siemens SIMATIC HMI IPC677C Operating Instructions Manual page 276

Glossary
Reset
Hardware reset: Reset/restart of the PC using a button/switch.
Restart
Warm start of a computer in operating state without switching off the power supply (Ctrl + Alt
+ Del)
Restore DVD
The Restore DVD is used to restore the system partition or the entire hard disk to factory
state if the system has crashed. The bootable DVD contains all the necessary image files.
You can also create a boot disk allowing restoration via the network.
SETUP (BIOS Setup)
A program in which information about the device configuration (that is, the configuration of
the hardware on the PC/PG) is defined. The device configuration of the PC/PG is preset with
defaults. Changes must therefore be entered in the SETUP if a memory extension, new
modules or a new drive are added to the hardware configuration.
Troubleshooting
Error cause, cause analysis, remedy
V.24 interface
The V.24 interface is a standardized interface for data transmission. Printers, modems, and
other hardware modules can be connected to a V.24 interface
Warm restart
The restart of a computer after a program was aborted. The operating system is loaded and
restarted again. The hot key CTRL+ ALT+ DEL can be used to perform a warm start.
276
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04