Operation; Power Supply Injection; Photography; Auto Black Balance (Abb) - Ikegami HDL-45E Operation Manual

5. OPERATION

5.1

Power Supply Injection

After connecting the camera with the peripheral system components, set the POWER switch on the camera rear panel to "ON"
and check to be sure that the POWER indicator comes on.
Display the image output of the camera on the HDTV color monitor connected with the camera.
CAUTION
POWER
indicator
5.2

Photography

5.2.1 Auto Black Balance (ABB)

Press the ABB switch, and the camera automatically adjusts the R/G/B black level.
Notice
Be sure to set the POWER switch of the camera to "OFF" before
connecting or disconnecting the peripheral system components.
Connecting or disconnecting during power on may cause failure of
the camera or the peripheral system components.
Camera rear view
POWER switch
DC IN connector
The AWB/ABB indicator lights in orange while auto black balance
is performed.
It turns off upon completion of auto black balance adjustment and
blinks upon failure. In the latter case, operate the ABB switch
again to cancel the blinking state.
5. OPERATION
AC connector
AC outlet
POWER
indicator
POWER
switch
DC OUT
connector
DC POWER cable
5 - 1
AC pack