30/ASSEMBLING THE ENGINE
Installing the stator
17.18
Adjusting the stator/rotor distance
17.19
Installing the oil pump drive gear (50 SX Mini)
17.20
Installing the reed valve housing, ignition coil, and intake flange
17.21
–
Position the stator.
–
Mount screws
Guideline
Screw, stator clamp
–
Position cable support sleeve
300473-11
–
Adjust the distance between stator
Guideline
Distance between rotor/stator
Feeler gauge (59029041100) (
–
Tighten screws
Guideline
Screw, stator clamp
300474-10
–
Position oil pump drive gear
–
Mount lock ring
300472-11
–
Position the gasket.
–
Position reed valve housing
300471-10
–
Position the ignition coil and intake flange.
–
Mount and tighten screws
Guideline
Screw, intake flange
–
Mount and tighten screw
Guideline
Screw, engine case
300469-10
but do not tighten yet.
M5
.
and rotor using special tool
p. 146)
.
M5
.
.
in the engine case opening.
.
M6
with the cable of the ignition coil.
M6x55
6 Nm (4.4 lbf ft)
.
0.35 mm (0.0138 in)
6 Nm (4.4 lbf ft)
5 Nm
Loctite
®
(3.7 lbf ft)
10 Nm (7.4 lbf ft)
89
243™