网络子卡; Removing The Network Daughter Card - Dell EMC PowerEdge R630 Owner's Manual

Identifier
Version
Status
网络子卡
网络子卡 (NDC) 是小型的可拆卸夹层卡。借助 NDC 可以灵活地选择不同的网络连接选项，例如 4 x 1 GbE、2 x 10 GbE 和 2 x
融合网络适配器。
Identifier
Version
Status

Removing the network daughter card

多数维修只能由经认证的维修技术人员进行。您只能根据产品说明文件中的授权，或者在联机或电话服务和支持
CAUTION:
团队的指导下进行故障排除和简单维修。任何未经 Dell 授权的服务所导致的损坏均不在保修范围之列。请阅读并遵循您的
产品附带的安全说明。
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Philips #2 screwdriver handy.
1. Remove the expansion card riser 3.
2. Using a Phillips #2 screwdriver, loosen the two captive screws that secure the Network Daughter Card (NDC) to the system
board.
3. Hold the NDC by the edges on either side of the touch points and lift to remove it from the connector on the system board.
4. Slide the NDC away from the back of the system until the Ethernet connectors are clear of the slot in the back panel.
5. Lift the NDC out of the system.
Figure 59. Removing the NDC
1. captive screw socket (2)
安装和卸下系统组件
120
GUID-19FB9DD2-7038-4746-8AFB-92883961211F
7
Translation Validated
GUID-4239FE5D-6EC1-4081-B8A4-1AC1DA371468
5
Released
2. connector on the system board