Table of Contents
Advertisement
Programming the Outputs
9.11.1 Changing or Unlinking an Analog Input
Tied to an Output Relay
Inputs linked to outputs must be un-linked prior to
being disabled.
Analog inputs tied to Feed type relays, use
pictogram
Blowdown type use B, and Event –
A,
other use C.
1- Press MENU
2- Scroll down to Set Feed Mode if used to
control a pump or Set Blowdown Mode if the
relay is used for bleed. Press OK
3- (Examples of each type)
4- Scroll down to the relay indicated in the 'In
Use' menu (Step 6 in 9.11) and press OK.
5- Change the relay to a different type of
control program, press OK and skip to step
6, or press OK for Sensor Control
6- Scroll up or down to the new sensor and
press OK
7- Press F1, 'Select' to save this choice.
8- Press ESC, Escape
Return to the 9.11 Disable an Analog or Digital Input
menu, to finish.
Page 62 of 102
Advertisement
Table of Contents
