Table of Contents
Advertisement
4- If you have a previously saved program, you have the
choice of saving F1 or loading F3.
In either case, press F1 SAVE to copy the current configuration to the USB
drive. When the save is complete, the display will notify you to remove the
USB drive.
13.2.1.2 Loading from the USB
1- To load a previously saved program from the USB to your
controller, press F3 Load.
2- The controller loads the program from your USB and notifies
you to remove it.
Sometimes referred to as "Cloning", a saved program file can be
loaded onto a different Aegis II controller. They will then have the same
configuration.
13.3 E-mail Reports and Alarms
The E-mail function is explained in the Aegis II Browser manual. You cannot access this feature through the
keypad. The following explanation is for informational purposes only.
The E-mail tool can send three types on information; Alarms, Status and Daily data. Setup is via a PC or smart
phone browser.
During controller power up or reset, E-mail initializes as disabled.
13.3.1 E-mail Types:
13.3.1.1 ALARM:
Lists all active alarms.
Includes enabled sensor, meter & contact values for alarm context
User Enabled/Disabled.
13.3.1.2
STATUS: Sent @ noon every day (12:00). Verifies that the controller is running & on the
LAN.
Includes enabled sensor, meter & contact values.
Sent @ midday so that commercial systems will have some run time and some day is left to respond
to operating issues.
13.3.1.3
DAILY:
LAN.
Includes enabled output run times or volumes and sensor, meter & contact values. User
Enabled/Disabled.
All types send comma delimited values(CSV); one line per I/O or Alarm so that the both the subject
& body can be easily parsed into a logging app, a typical use for the DAILY type.
Will make text-to-speech entertaining (bit encoded value-states are therefore intentionally excluded).
Sent once when an alarm first occurs.
Sent @ midnight (23:59) every day. Verifies that the controller is running & on the
Page 98 of 102
Spare Parts and Accessories
Configure file
AC123_16_292.cfg
SAVE=capture config:
SAVE
NEXT
AC123_16_292.cfg
complete
Remove USB drive
Re-configure file
Writing 6
SAVE=capture config:
SAVE
NEXT
AC123_16_292.cfg
Complete restarts
Remove USB drive
LOAD
LOAD
Advertisement
Table of Contents
