Table of Contents
Advertisement
Programming the Inputs
9.10.2 Link a Water Meter to a Relay (Applies
to all relays )
Relays must be configured for Feed mode. See 10.6
Frequency relays set for ON/OFF mode are
configured the same as relays 1-5.See example A.
For pulse output relays, use example
1- Press MENU
2- Scroll to Set Feed Mode then press OK
3- Scroll to the desired relay. Press OK
4- Select the Feed Mode type: Water Meter
and press OK
5- Scroll to select the meter and press F1 to
Select and then OK
6- Use arrow keys to edit the measure value
7- Press the F1 key, OTHER, to move to the
Feed volume value.
8- Set the relay ON time in seconds or a PPM
set-point.
9- Press OK to save
B.
Page 60 of 102
Advertisement
Table of Contents
