Table of Contents
Advertisement
2
Navigating the [Menu] display
Name of menu item
[Home]
[Adjust Set-points]
[Prime, Force ON]
[Water Meter Setup]
[Adjust Alarms]
[Biotiming, Events]
[Set Feed Mode]
[Set Blowdown Mode]
[I/O Setup]
[I/O Status]
[System]
Table 2 Main Menu lookup
Figure 4 Typical default screen
The default display exhibits up to six current sensor values, and STATUS, ALARM and SETPNT buttons. The sensor
choices can be changed or rearranged. See section
button (F1) is explained in section
latest alarms for all I/O points. See also section
The SETPNT button (F3) allows the user to edit the set-point of any enabled relay using set-points.
Jump to chapter
Return to the default display (See below)
Chapter 10.6.2 Feed Based on a Sensor
Chapter 10.14 Prime, Force On a Relay
Chapter 9.10.1 Configure a Digital Input as a Water Meter
Chapter 9.8.1 Analog Alarm Configuration
Chapter 10.7 Configuring an Event-Other relay
Chapter 10.6 Configuring a Feed Relay
Chapter 10.5 Configure a Blowdown Relay
Chapter 9.1 Analog and Digital Inputs
Chapter 10 Programming the Control Outputs Use this menu
choice to monitor the I/O
Chapter 11 System Menu
Figure 4A Screen if any alarm present
2.2 How to Modify the Display's 'Home' Screen.
Status. The Alarm button (F2) allows the user to view and clear the
2.1 Input/Output
9.8.1 Analog Alarm
Page 7 of 102
Configuration, for more information on alarms.
Menu Navigation
The STATUS
Advertisement
Table of Contents
