Table of Contents
Advertisement
8
Commissioning
User qualification: trained user, see
'Users' qualifications'.
After mechanical and electrical installation, turn on
the sample stream, check for leaks and purge any
trapped air.
8.1 Switch-on behavior during
commissioning
Switching On - First Steps
Power up sequence will first show the 4 line
x 20 character LED display for 3 seconds:
Followed by the "Home" screen of up to 6 sensor
readings with the bottom line reserved for labels
above the 3 dynamic keys F1, F2 and F3:
all the electrical connections
correctly
the
voltage
on the data plate
Chapter 4.4
control
the
Page 47 of 102
8.2 Defining Metering and Control
Processes
Define the following parameters to set up a
controller:
What type of a process control is planned?
Which measured variables are there?
Is there an in-line, batch or circulation
process planned?
Should the controls operate as ON/OFF,
proportional or PID control?
Which control variables are there?
What control parameters are necessary?
How should the feeders and actuators be
controlled?
How should any mA inputs or outputs be
configured?
Are there chemicals to be fed using timed
feed or a fluorescent marker/dye?
9
Programming the Inputs
This section will depict the keystrokes necessary to
edit the program, calibrate sensors or find
information.
For a faster and easier initial
configuration, ProMinent recommends
that general configuration of the
controller, especially during
commissioning, be performed using a
portable computing device like a laptop
or a tablet computer. Refer to the Aegis
II Browser manual for more information.
The keypad interface instructions in this
manual are intended to show an
operator how these individual tasks can
be performed from the keypad.
Communication
Advertisement
Table of Contents
