Table of Contents
Advertisement
Programming the Outputs
10.7.2 Add, Remove, Edit Events
10.7.2.1 Adding Events
Once a relay is enabled as an Event – Other
output, you can add, remove or edit events.
From the Prebleed/Lockout menu, press F1
Add. If you are not in that menu, press the
Menu key and scroll down to Biotiming,
Events and press OK. Scroll down to your
relay and press OK again. Press F1 Add.
Depending on the cycle chosen, you will see
slightly different screens.
Follow your cycle below.
1- The Add screen presents a default day, start
time and pump ON time. Use the arrows to
edit these values and press F1 to save the
changes.
Use the left/right arrows to choose a
2-
frequency. ONCE will enter only the event
you set. It will repeat each cycle. (Once a
day, once a week or once every 4 weeks.)
Page 72 of 102
Advertisement
Table of Contents
