Keysight Technologies B2961A User Manual page 156

NOTE
NOTE
NOTE
NOTE
Front Panel Operations
This chapter explains how to use the Keysight B2961A/B2962A.
• "Basic Operations"
• "To Use Functions other than Measurement"
• "To Set Source Output"
• "To Execute Measurement"
• "To Use Math Function"
• "To Use Trace Buffer"
• "To Use Program Memory"
Turning the instrument on or off
Press the standby switch. When the power is on, the LED below the switch is turned
green.
Setting the instrument to local mode
Press the Cancel/Local key.
The front panel keys are available when the instrument is in local mode.
Enabling or disabling the channel
Press the On/Off switch.
The channel status is indicated by the lighting status of the switch as follows.
Off: The channel is disabled.
Green: The channel is enabled.
Red: The channel is in the high voltage state.
Starting measurement
Press the Trigger key. According to the setting conditions, the single (one shot)
measurement is performed with the DC bias output, pulsed bias output, arbitrary
waveform output, staircase sweep output, or pulsed sweep output.
Press the Auto key. The repeat (continuous) measurement is performed with the DC
bias output (of the Source value).
5-2 Keysight B2961A/B2962A User's Guide, Edition 3