Inspecting The Shipment; Checking The Operation Of Keysight B2961A/B2962A - Keysight Technologies B2961A User Manual

Installation

Inspecting the Shipment

Inspecting the Shipment
Perform the following inspections when the Keysight B2961A/B2962A and
accessories arrive at your site.
1. Before unpacking any component, inspect all boxes for any signs of damage that
might have occurred during shipment, such as:
• dents
• scratches
• cuts
• water marks
If you suspect any damage, contact your nearest Keysight Sales and Support
Office.
2. When you open the boxes that contain the B2961A/B2962A and accessories,
check the components against the contents lists attached to the boxes.
If anything is missing, contact your nearest Keysight Sales and Support Office.
3. Verify the operation of B2961A/B2962A as described in
Operation of Keysight B2961A/B2962A" on page
If any problem occurs, contact your nearest Keysight Sales and Support Office.

Checking the Operation of Keysight B2961A/B2962A

1. Make sure that the standby switch is set to off.
2. Connect the power cord from the B2961A/B2962A's rear panel AC input
connector (receptacle) to an AC power outlet at your site.
3. Press the standby switch to turn on the instrument.
The initialization screen will appear on the B2961A/B2962A's front panel
display, and the power-on self-test is automatically executed.
If the B2961A/B2962A is operating normally, the front panel LCD displays as
shown in Figure 3-1
3-4
or 3-2.
Keysight B2961A/B2962A User's Guide, Edition 3
"Checking the
3-4.