Sweep Output; To Set Sweep Output - Keysight Technologies B2961A User Manual

Figure 6-3
Linear Sweep
Logarithmic Sweep

Sweep Output

The channel can apply a sweep voltage/current. It supports several sweep output
functions, as shown in
but performs the measurement for each sweep step as shown in Figures
The channel can also perform an arbitrary waveform output as the sweep source and
perform the measurement for each step of the waveform. It is called as list sweep.
For details, see "List Sweep" on page
Variety of Sweep Outputs
Single Sweep
Pulse output
DC output
Pulse output
DC output

To Set Sweep Output

The following points must be noted when setting the sweep output.
• To set the function parameters, see
• To set the ranging mode of the sweep source, see
4-30.
• To set the sweep direction, see
• To set the output condition after sweep, see
• To set the pulse delay time and the pulse width, see
4-19.
Keysight B2961A/B2962A User's Guide, Edition 3
Figure 6-3. The channel not only performs the sweep output
6-10.
DC output
DC output
"Function Parameters" on page
"Sweep dialog box" on page
Function Details
Double Sweep
Pulse output
Pulse output
"Sweep dialog box" on page
4-30.
"Sweep dialog box" on page
"Pulse Parameters" on page
Sweep Output
6-1 and 6-2.
4-13.
4-30.
6-9