Keysight Technologies B2961A User Manual page 152

Start-up
Sound
Language
Front Panel Reference
System key group
Auto CLR Displays the following softkeys for setting the automatic clear
of the timestamp. The present setting is indicated by an asterisk
on the softkey label.
OFF
ON
Displays the System Start-up dialog box which provides the following setup
parameters.
Power-on State
Power-on Program
Displays the following softkeys to enable or disable the beep and sound. The present
setting is indicated by an asterisk on the softkey label.
OFF Disables the beep and sound.
ON Enables the beep and sound.
Displays the following softkeys for specifying the B2961A/B2962A remote control
command set. The present setting is indicated by an asterisk on the softkey label.
Default Specifies the default command set which supports all functions.
Script Not effective.
Only the default command set is available.
4-50
Disables the automatic clear of the
timestamp.
Enables the automatic clear of the
timestamp.
Power-on state, RST, RCL0, RCL1, RCL2, RCL3, or RCL4
The power-on state can be selected from the factory default
reset condition (RST) and user conditions RCL0, RCL1,
RCL2, RCL3, and RCL4 which can be defined by using the
*SAV 0, *SAV 1, *SAV 2, *SAV 3, and *SAV 4 commands,
respectively, while the B2961A/B2962A is in the remote
mode.
Power-on program execution ON or OFF
If this parameter is ON, the power-on program is
automatically executed when the B2961A/B2962A is turned
on.
The power-on program can be defined by using the
:PROG:PON:COPY command while the B2961A/B2962A
is in the remote mode.
Keysight B2961A/B2962A User's Guide, Edition 3