Table of Contents
Advertisement
Instructions for use
4.2.2 Emergency stop
4.2.3 Lights which indicate alarms (extra equipment)
4.2.4 Changing the water
Washing heavily soiled items and other types of items
The machine can be additionally fitted with a photocell (15) at the outfeed. The pho-
tocell has a stop function when items other than trays and cutlery are to be washed,
e.g. heavily soiled items. The control panel then has an additional knob (12) for ac-
tivation of the photocell. In this case, the machine must run in manual mode.
PHOTOCELL
1
0
Knob for activation of photocell (15). (Extra equipment)
•
Activate the photocell by turning the knob (12) to position 1.
•
Press button (4) for manual operation. The machine starts and runs continuously.
•
When the washed items activate the photocell (15) on the outfeed, the con-
veyor stops. The belt will restart when the items have been removed.
•
If the machine is being run in manual mode and trays are fed onto the tray
conveyor, the machine switches to automatic mode.
The machine has three emergency stop buttons. One of the emergency stop but-
tons (11) is located beneath the control panel. The other emergency stop buttons
(27) are located at the infeed and outfeed. If the machine has been stopped by an
emergency stop button being pressed when the machine is running, the emer-
gency stop button must be reset by turning it in the direction of the arrows. Then
press button (5) to restart the feed.
The alarm light (16) indicates the following:
•
Green light = Machine in operation.
•
Yellow light = Alarm. Check the message on the control panel display. Rec-
tify the cause of the alarm. See the section "Operating problems".
•
Red light = Serious fault. Check the message on the control panel display.
Contact service personnel.
For best wash results, it is important that the water in the tanks is changed when
it becomes too dirty. The water should always be changed if foam begins to form
in the washing tanks.
•
Switch the machine off by pressing button (10).
•
Remove the filter from the pre-wash tank and empty the machine by turning
the outlet seals (29, 30) a quarter of a turn.
•
Clean the tanks, outlet seals and filters. Refit the components.
•
Refill the machine. See "Filling and heating the machine".
WD-59CT & WD-66CT
66CT_17
31
Rev. 2.0 (20110124)
Advertisement
Table of Contents
