3. Installation
3.3
Laying the tubing
Connecting
3-8
If elbow connectors or multiple distributors are used,
the airflow will be reduced slightly.
Proceed as follows:
1. Push the tubing as far as possible into or over the tube
coupling of the threaded connector.
2. Tighten the clamping screw 1 or, if applicable, pull the
locking ring 2 over the tube coupling.
3. Seal connections that are not required with blanking
plugs 3.
4. For better system clarity, bundle together the installed
tubes with:
– tubing straps or
– multi-tube holder
Fig. 3/1: Fitting the tubing
1
2
3
Festo P.BE-CDVI-EN en 1202e