2. Assembly
1
1
1
Mounting holes
Fig. 2/1: Position of the mounting holes
2-6
2. Make sure that your mounting surface can support this
weight and that it is sufficiently earthed.
Note
Attaching the CDVI manifold block:
– The 8-valve manifold block must always be fastened to
all 4 M6 drill holes.
Attaching the CDVI with expansion blocks:
– 1 valve position may protrude unfastened.
– If the expansion provides more than one valve position,
fasten the last expansion block. However, please note
that a maximum of 4 valve positions may lie unsup-
ported between the manifold block and last expansion
block, i.e. you need to fit an intermediate retainer after
4 valve positions at the latest.
3. Drill corresponding mounting holes
mounting surface.
∅
6 mm into the
Festo P.BE-CDVI-EN en 1202e