Connecting The Cdvi; Connecting The Pneumatic Lines - Festo CDVI-DN Description

3. Installation
3.5

Connecting the CDVI

3.5.1 Connecting the pneumatic lines

3-18
Directional control
valve
Ident. code R and X
Ident. code S and W
Tab. 3/6: Ports at the valves with ident. code R, S, X and W
In the case of connecting plates fitted with blanking plates,
seal the working lines (2) and (4) with blanking plugs or
threaded blanking plugs to prevent dirt from entering.
For optimum efficiency of your terminal, the compressed air
supply and the exhausting should take place in the following
cases via the left and right-hand end plates:
– On valve terminals with more than 10 valves (nominal
supply pressure 6 bar)
– On large capacity actuators:
Compressed air or
vacuum via port
(4)
(2)
Festo P.BE-CDVI-EN en 1202e
Exhaust via port
(3)
(5)