Festo CDVI-DN Description page 23

1. Overview of components
Component
Valves and blanking
plate
*)
Separator plates
End plates, right
End plates, left
*)
Pressure zones are only possible for CDVIs with at least one expansion block.
Tab. 1/3: Pneumatic components of the CDVI
1.3.2 End plates
Festo P.BE-CDVI-EN en 1202e
Note
With more than 2 pressure zones:
Ensure that there is a corresponding pneumatic supply
port for each pressure zone.
Separator plates with sealing function are located between the
manifold block and the expansion block. There are designs with
or without channel separation (see following table).
The in-line valve manifolds of the CDVI can be fitted with the
following components:
Design/type
see Tab. 1/4
–
All supply ducts open: CDVI5.0-EB-DZ
–
Separating the compressed air channel (1): CDVI5.0-EB-DZP
–
Separating the exhaust duct (3/5): CDVI5.0-EB-DZR
–
Separating the compressed air channel and the exhaust duct: CDVI5.0-EB-
DZPR
–
For operating the CDVI with internal pilot air supply: CDVI5.0-EPR
–
For operating the CDVI with external pilot air supply: CDVI5.0-EPR-S
–
With CDVI-MP: CDVI5.0-EPL-MP-... (with electric multi-pin and cable)
–
With CDVI-FB: CDVI5.0-EPL-FB
The CDVI possesses as mechanical termination of the terminal
both a left and a right-hand end plate. These end plates fulfil the
following functions:
1-9