Laying The Tubing - Festo MPA-L Series Description

3. Installation
Replacement

3.4.2 Laying the tubing

Mounting
1
Cartridge fitting
2
Locking ring
Fig. 3/6: Fitting the tubing
3−18
Proceed as follows:
1. Check that the installed clamp straps can be seen from
the underside of the valve terminal.
If not: First loosen the screws of the valve that is mounted
over the sub−base concerned and remove the valve so
that the clamp strap can be removed from above.
2. For pneumatic supply plates:
Loosen the screws on the upper part (exhaust plate and
cover plate of the silencer) and remove it.
3. Using a narrow slotted screwdriver lever the clamp strap
over the lugs and remove it.
4. Pull the cartridge out and replace it with a suitable type
(see Tab. 3/3).
Note
Seal unused connections with a blanking plugs to
·
ensure the reliability of the valve terminal.
Proceed as follows:
1. Press the hose into the hose connector as far as the stop
(see Fig. 3/6).
2. Check the secure attachment of the hose to the cartridge.
3. For reasons of clarity, bundle the tubing together with:
Tube straps or
Multiple tubing holders
1
2
Festo P.BE−MPAL−EN en 1008NH