Contents and general safety instructions
Notes on the use of this manual
Festo P.BE-CDVI-EN en 1202e
This manual contains specific information on fitting, installing,
commissioning, servicing, converting and cleaning the
CDVI. The manual describes only the following pneumatic
components:
–
2/2-way valves (monostable)
–
Two 3/2-way valves (monostable) per valve housing
–
3/2-way valves (monostable), with external compressed
air supply
–
5/2-way valve (monostable and bistable)
–
5/3-way mid-position valves
–
Manifold block
–
Expansion block (with 1 or 2 valve positions) without
additional supply
–
Expansion block (with 1 or 2 valve positions) without
additional pneumatic supply
–
Expansion block (with 1 or 2 valve positions) with
additional electrical supply (only on fieldbus version)
–
Expansion block (with 1 or 2 valve positions) with
additional pneumatic and electrical supply (only on
fieldbus version)
–
Separator plates without duct separation or separator
plates with duct separation for forming up to 9 pressure
zones
–
Right-hand end plates for internal or external pilot air
supply
–
Left-hand end plate, on the CDVI-MP with internal multi-pin
plug connection
VII