Figure 8-1. Optional X-Slot Cards; Communication - Eaton Power Xpert 9395 Installation And Operation Manual

Hide thumbs Also See for Power Xpert 9395:

page of 218

/ 218
Contents
Table of Contents
Bookmarks

Table of Contents

Chapter 8

Communication

This chapter describes the communication features of the Eaton Power Xpert 9395P-300 UPS system and

provides information about connecting hardware. For terminal wiring information, see paragraph 3.2.6 and

paragraph 4.7. For location of the customer interface panels and terminals, see Figure 4-5 and Figure 4-10

through Figure 4-13.

8.1

X-Slot Cards

The 9395P-300 UPS system has four standard, factory-installed X-Slot communication bays. See Figure 4-18

on page 4-24 for bay locations. The UPS is compatible with the following X-Slot cards (see Figure 8-1):

Power Xpert Gateway Card - provides a data gateway from the UPS to the Power Xpert software; provides

remote monitoring through a Web browser interface, e-mail, and a network management system using

SNMP; connects to a twisted-pair Ethernet (10/100BaseT) network. Modbus TCP support provides direct

integration of the UPS parameters to a Building Management System (BMS). It has a built-in switching hub

that allows one additional network device to be connected to the network without the requirement of an

additional network drop.

Modbus Card - provides direct integration of UPS information (meters and status) to a Building Management

System (BMS) using the Modbus RTU protocol.

Relay Interface Card (AS/400) - has isolated dry contact (Form-C) relay outputs for UPS status: Utility failure,

Low battery, UPS alarm/OK, or On bypass when interfacing with IBM AS/400 computers, other relay

connected computers, and industrial applications.

Industrial Relay Card (IRC) - indicates the operating status of the UPS system using the customer's

monitoring equipment. The IRC uses four isolated normally-open or normally-closed dry relay contacts to

indicate the UPS status. Online, Bypass, Battery, and Alarm modes can be monitored.

Hot Sync CAN Bridge Card - provides connectivity for operational mode control and metering of a parallel

system at any UPM in the system. In addition, this card can be used to connect optional system monitoring

devices, such as a Remote Monitor Panel II (RMP II), a Relay Interface Module II (RIM II), or a Supervisory

Contact Module II (SCM II) to the UPS.

LAN drops for use with X-Slot connectivity cards must be provided by facility planners or the customer.

For installation and setup of an X-Slot card, contact an Eaton service representative (see page 1-10). Refer to

the manual supplied with the X-Slot card for user instructions.

Relay Interface Card