Status Indicators - Eaton Power Xpert 9395 Installation And Operation Manual

When the unit powers up, the screen displays as shown in Figure 7-2. When power is applied to the system,
the display advances to the Sign In screen shown in Figure 7-3.
7.3.1

Status Indicators

The symbols on the bottom of the control panel are status indicators. These colored light emitting diode (LED)
lamps work with the alarm horn to let you know the operating status of the UPS. See Table 7-1.
Table 7-1. Status Indicators
Indicator
Lit Steady
Green
Lit Steady
Yellow
Lit Steady
Yellow
Lit Steady
Lit Flashing
Red
7.3.2 Using the Touch Screen
The touch screen control panel provides an operator interface with the UPS system. Figure 7-3 identifies the
display areas discussed in the following sections.
Touching anywhere on the screen brings up the Sign In Request pop-up. Touch the X in the upper right corner
of the pop-up, then touch the padlock symbol in the upper right corner to obtain the password request pop-up
(see Figure 7-4).
® ®
Eaton Power Xpert 9395P-300 (300kVA, 300kW) UPS Installation and Operation Manual
Status Description
The UPS is in Online mode, operating normally. The power module is supplying power to the critical
load.
The UPS is in Battery mode. Because Battery mode is a normal condition of the UPS, the Online
indicator also remains illuminated.
The UPS is in Bypass mode. The critical load is supported by the bypass source. The Online indicator is
not illuminated when the system is in Bypass mode.
The UPS has an active alarm and requires immediate attention. The screen shows the highest priority
active alarms. All alarms are accompanied by an audible horn. To silence the horn, press any control
panel pushbutton once. The Alarm indicator may be illuminated along with other indicators.
There is a new UPS alarm condition. The indicator flashes until acknowledged by pressing anywhere
on the control panel once.
P-164000563—Rev 04 www.eaton.com/powerquality
UPS Operating Instructions
7-3