Installing Options, Accessories, And Distributed Bypass Control Wiring; Initial Startup; Completing The Installation Checklist - Eaton Power Xpert 9395 Installation And Operation Manual

Hide thumbs Also See for Power Xpert 9395:

Table of Contents

4.11

Installing Options, Accessories, and Distributed Bypass Control Wiring

To install options, accessories, and distributed bypass control wiring, see Chapter 5, "Installing Options and

Accessories".

4.12

Startup and operational checks must be performed by an authorized Eaton Customer Service Engineer, or the

warranty terms specified on page W-1 become void. This service is offered as part of the sales contract for the

UPS. Contact an Eaton service representative in advance (usually a two-week notice is required) to reserve a

preferred startup date.

4.13

The final step in installing the UPS system is completing the following Installation

Checklist. This checklist ensures that you have completely installed all hardware, cables, and other equipment.

Complete all items listed on the checklist to ensure a smooth installation. Make a copy of the Installation

Checklist before filling it out, and retain the original.

After the installation is complete, an Eaton Customer Service Engineer must verify the operation of the UPS

system and commission it to support the critical load. The service representative cannot perform any

installation tasks other than verifying software and operating setup parameters. Service personnel may request

a copy of the completed Installation Checklist to verify all applicable equipment installations have been

completed.

Eaton

Power Xpert

9395P-300 (300kVA, 300kW) UPS Installation and Operation Manual

NOTE

The Installation Checklist MUST be completed prior to starting the UPS system for

the first time.

P-164000563—Rev 04 www.eaton.com/powerquality

Installation

4-35

Table of Contents