Enter The Measurement Parameters; Perform A User Two-Port Calibration - HP 8712ES User Manual

NOTE
NOTE
Making Measurements
Measuring Impedance using the Smith Chart

Enter the Measurement Parameters

Press the following keys on the analyzer:
PRESET
( User Preset or
MEAS 1
S11 Refl Port1
Center
FREQ
Span MHz
200
This example measurement uses the default instrument parameters for
an S measurement. If your particular measurement requires different
11
parameters (such as frequency range, source power level, number of data
points, and sweeptime) enter them now.

Perform a User Two-Port Calibration

Refer to the section
Calibration" on page 3-19
calibration.
If you are testing a one-port device, refer to the section
One-Port Calibration" on page 3-49
one-port calibration.
3-74
Factory Preset
MHz
175
"Measuring S-Parameters using a Two-Port
for examples of how to perform a user two-port
for an example of how to perform a
)
"Perform a User
ES User's Guide