Step 3. Check The Analyzer Operation - HP 8712ES User Manual

Step 3. Check the Analyzer Operation

1. Turn on the line switch of the analyzer. After approximately 30
seconds, a display box should appear on the screen with the following
information:
• the model number of your analyzer (either HP 8712ES or
HP 8714ES)
• the firmware revision
• the serial number of your analyzer
• installed options
2. Verify that the serial number and options displayed on the screen
match the information on the rear panel serial label.
3. The operator's check should be performed on the analyzer to provide a
high degree of confidence that the analyzer is working properly. Refer
to Chapter 2, "Getting Started,"
the operator's check.
ES User's Guide
Installing the Analyzer
Step 3. Check the Analyzer Operation
for instructions on how to perform
1-9