HP 8712ES User Manual page 335

Ethernet
Address
Expand on OFF
Ext Ref on OFF
External Point
External Sweep
Softkey in the LAN port setup menu. Displays the Ethernet address,
which is a 48-bit number assigned at the factory to be used to identify a
machine on the network. The Ethernet address cannot be changed.
See The LAN Interface User's Guide Supplement for more information.
Access Keys:
SYSTEM OPTIONS
Softkey in the more display menu. Toggle to ON if you want to expand
the measurement display to the full screen size and eliminate all
annotation except marker annotation.
See "Expanding the Displayed Measurement" on page 4-52
information.
Access Keys:
DISPLAY
Softkey in the source
network analyzer to use the external 10 MHz signal as the frequency
standard. When the Ext Ref feature is toggled ON and a signal is not
present at the EXT REF IN connector, the network analyzer will not
sweep. Default is OFF.
NOTE
Softkey in the trigger source menu. Enables the analyzer to sweep to
the next (frequency) point when externally triggered through the EXT
TRIG IN/OUT rear panel connector. The analyzer sweeps one point per
trigger.
Access Keys: MENU
Softkey in the trigger source menu. Enables the analyzer to begin one
complete sweep when externally triggered.
Access Keys:
MENU
ES User's Guide
LAN
More Display
. Toggle to ON if you want to set the
MENU
The external reference should be disconnected
from the EXT REF IN or power reduced when not
in use.
Trigger Trigger Source
Trigger Trigger Source
Hardkey/Softkey Reference
LAN Port Setup
for more
E
8-29