Making Measurements
Measuring Devices with Your Network Analyzer
Measurement
Icon Appears on the Analyzer's Display
Display Icon
When Measuring:
Any of the four S-parameters (with two-port
calibration) when sweep time is less than 3.0
seconds.
Either of the two forward S-parameters (with
two-port calibration) when sweep time is more
than 3.0 seconds.
Either of the two reverse S-parameters (with
two-port calibration) when sweep time is more
than 3.0 seconds.
S
standards.
S
standards.
S
calibration), power, conversion loss, or
calibration standards.
S
calibration), or calibration standards.
1. When calibration standards are being measured, a "Cx" is displayed
on the annotation line, indicating non-corrected, non-simultaneous
measurements are being made.
3-8
(not with two-port calibration) or calibration
11
1
(not with two-port calibration) or calibration
22
1
or fault location/SRL (not with two-port
21
or fault location/SRL (not with two-port
12
1
1
ES User's Guide