Deleting A Component; Connecting Component With Multiple Devices - Otto Bock 17KO1 Series Instructions For Use Manual

2) In the navigation menu, tap the entry "Manage components".
3) Briefly press the
of the Bluetooth connection for 2 minutes.
4) Tap the "+" button.
→ The Connection Wizard opens and guides you through the process of establishing a con­
nection.
5) Follow the subsequent instructions on the screen.
6) After the Bluetooth PIN is entered, a connection to the component is established.
→ While the connection is being established, 3 beep signals sound and the
appears.
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. This
process may take up to a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
If establishing a connection to a component is not possible, perform the following steps:
Delete the component from the Cockpit app if applicable (see the section "Deleting a com­
►
ponent").
► If present, delete the component from the Bluetooth settings on the device (unpair).
► Rest the component by connecting and disconnecting the battery charger.
► Add the component again in the Cockpit app (see the section "Adding a component").
INFORMATION
After activating the "visibility" of the component (briefly pressing the
can be recognised by another device (e.g. smartphone) within 2 minutes. If registration or
establishing the connection takes too long, the process of establishing a connection is can­
celled. In this case the

7.4.2 Deleting a component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Tap the "Edit" button.
4) Tap the symbol under the component you want to delete.
→ The component is deleted.

7.4.3 Connecting component with multiple devices

The connection for a component can be stored on more than one device. However, only one
device can be connected to the component at one time.
If there is an existing connection between the component and a different device, the following
information appears while the connection is being established with the current device:
Connect to this component?
Component was connected to
another device.
Establish connection?
Cancel
button on the control panel of the joint unit to activate recognition (visibility)
button on the control panel must be briefly pressed again.
► Tap the OK button.
→ The connection to the last connected device is broken off
and established with the current device.
OK
symbol
button), the component
77