Connecting The Power Supply And Battery Charger; Connect Battery Charger To The Product - Otto Bock 17KO1 Series Instructions For Use Manual

6.1 Connecting the power supply and battery charger

1
1) Slide the country-specific plug adapter onto the power supply until it locks into place (see
fig. 1).
2) Connect the round, four-pin plug of the charging cable to the OUT receptacle on the battery
charger so that the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
3) Connect the round, three-pin plug of the power supply to the 12 V receptacle on the battery
charger so that the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
4) Plug the power supply unit into the wall socket.
→ The green LED on the back of the power supply (see fig. 3) and the green LED on the bat­
tery charger light up.
→ If the green LED on the power supply and the green LED on the battery charger do not light
up, there is an error (see Page 99).

6.2 Connect battery charger to the product

2
1) Open the charging receptacle cover.
2) Connect the charging plug to the charging receptacle of the
product.
INFORMATION: Take note of the plug direction!
→ After the displays are tested, a short beep is emitted followed by
3 short vibration signals.
→ If the symbol lights up, this means an error was identified
during the self-test (see Page 94).
3) The charging process starts.
→ Once the product battery is fully charged, the yellow LED on the
battery charger turns off.
→ To check the charge level while the battery charger is connec­
ted, briefly press the
4) Disconnect the product after the charging process is complete.
→ After disconnecting the battery charger, a vibration signal is
emitted followed by a short beep and the current status is dis­
played for approx. 5 seconds (see Page 94).
→ When the symbol in the
is switched on and operational.
5) Close the charging receptacle cover.
3
button on the control panel.
button is lit up green , the product
71