Basic Mode; Mymode "Training Mode - Otto Bock 17KO1 Series Instructions For Use Manual

• Check whether the battery charger is connected. Changing the mode is not possible when
the battery charger is connected, even though the
• On the device, check whether a connection to the component has been established. The
symbol must be lit up.
• On the device, check whether the correct component has been selected.
Switching process
Product

1. Basic Mode

2. Training mode
1
2
4. User defined
3. Freeze position
3
100% 1. Basic Mode
9.2 Basic mode
This mode is intended for daily use.

9.3 MyMode "Training mode"

(if the knee joint is locked during the stance phase and swing phase release is possible)
The knee joint is locked in the stance phase. Swing phase initiation is possible as in basic mode.
In this mode, walking down stairs or a ramp is only possible one step at a time.
Switching process
1) On the screen of the device, tap the corresponding symbol to activate
2) The hydraulics stabilise the joint with high flexion resistance in the stance
Exit training mode by selecting a different MyMode or by turning the compon­
ent off and then on again.
1) Tap the symbol of the desired MyMode (1) in the main menu
of the Cockpit app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the act­
ive mode.
→ The current mode is also indicated by the name on the
training mode.
→ A confirmation signal sounds to indicate the switch to training mode.
phase and release the joint in the swing phase so that the leg can swing
forward freely.
symbol is lit up.
lower edge of the screen (3).
87