Switching The Product On/Off - Otto Bock 17KO1 Series Instructions For Use Manual

Parameter
Volume of acoustic
signal
Pitch of acoustic
signal
INFORMATION
Confirmation of the successful transfer of the parameters
A beep and vibration signal is emitted by the orthosis while changing the parameters using the
Cockpit app. If the parameter "Volume of acoustic signal" is set to "0", only a vibration signal
is emitted.

8.5 Switching the product on/off

In certain cases, e.g. for storage or transportation, the product can be purposely switched off.
CAUTION
Using the product while switched off
Falling due to unexpected product behaviour because of changed damping behaviour.
► Prior to using the product, briefly press the
it is switched on. The button symbol lights up green
Switching off
1) Briefly press the
The symbol in the button lights up green
Page 94).
2) With the product switched on, press and hold the
symbol in the button turns off and a descending series of beeps (shut-down melody)
emitted.
Switching on
► Press the button on the control panel to switch the product on.
→ A long vibration signal followed by a short beep is emitted, and the current status is displayed
for about 5 seconds (see Page 94).
→ When the symbol in the
tional.
→ Basic mode is activated after switching on.
INFORMATION
No display after switching on
If the symbol does not light up after a long press of the
discharged. Charging for at least 15 minutes is required in this case.
Adjustment Cockpit app
app setting adjustment
range range
0 to 100 0 to 100
1500 Hz — 1500 Hz —
3000 Hz 3000 Hz
button on the control panel to check whether the product is switched on.
button is lit up green
Meaning
Volume of beep signal for confirma­
tion tones (e.g. when switching
MyModes). The "0" setting deactiv­
ates the audible feedback signals.
However, warning signals are still
generated if errors occur.
Pitch of beep signal for confirmation
tones
button on the control panel to check whether
when the product is switched on.
and the current charge level is displayed (see
button on the control panel until the
, the product is switched on and opera­
button, the battery may be deep
is
85