ABB REACT 2 Series Product Manual page 73

with the REACT2 system. Set the parameters of the meter as set out
in the table:
Parameter
Address
Protocol
Baud rate
Parity
The settings are made by using the keypad and the display on the meter:
1. Press for two seconds
2. Press repeatedly until the display shows "Set".
- Press
3. Press repeatedly until the display shows "RS-485".
- Press
4. Press repeatedly until the display shows "Protocol".
- Press to access.
- Press to enable the change in the value.
- Press repeatedly until the display shows "Modbus".
- Press
- Press for two seconds
5. Press repeatedly until the display shows "Baud rate".
- Press to access.
- Press to enable the change in the value.
- Press repeatedly and select 19200.
- Press
- Press for two seconds
6. Press repeatedly until the display shows "Address".
- Press to access.
- Press to enable the change in the value.
- Press repeatedly and select 1.
- Press
- Press for two seconds
7. Press repeatedly until the display shows "Modbus".
- Press to access.
- Press to enable the change in the value.
- Press repeatedly and select even.
- Press
- 73 -
Settings
1
MODBUS
19200
EVEN
to access the setup menu of the meter.
to return to the RS485 menu.
to return to the RS485 menu.
to return to the RS485 menu.
5 - Installation