Mounting Instruction - React2 System - ABB REACT 2 Series Product Manual

M
ounting instruction - REACT2 system
so that it is perfectly level on the wall
and use it as a drilling template.
choose an appropriate type of screw
anchors for the attachment points. The
choice must be based on the type of
support (wall, frame or other support),
the type of anchors to be used, and
their ability to support 4 times the
inverter's weight (4x22Kg=88Kg).
Depending on the
anchor chosen, drill the required
A
2 holes to mount the bracket.
REACT2-UNO bracket
support.
2 x 9 mm
Ø
20
B
B
01
type of
01 to the
01
- 62 -
2 x 9 mm
Ø
A
The underlying procedure is related
to the side-by-side installation of
REACT2-BATT. Alternatively,
possible to install the REACT2-BATT
separately and at greater distances
cable kit (2 meter cables length).
that it is perfectly level on the wall and use it as
a drilling template. To aling the two brackets
use the reference point and follow the steps
as in the picture.
an appropriate type of screw anchors for the
attachment points. The choice must be based
on the type of support (wall, frame or other
support), the type of anchors to be used, and
their ability to support 4 times the inverter's
weight (4x50Kg=200Kg).
the required 2 holes
support.
5 - Installation
01
A
is
so
20
B to mount the bracket.
to the
20