ABB REACT 2 Series Product Manual page 121

Frequency Control: P(f) (Only with Admin Plus privileges)
In the Frequency Control: P(f)
lated to the active power derating as function of grid frequency.
Do not change these parameters if not requested by the grid operator.
Ramp Control (Only visible with Admin Plus privileges)
In the Ramp Control
the active power ramp up at the start-up and after a grid fault event.
Do not change these parameters if not requested by the grid operator.
Reactive Power Control (Only with Admin Plus privileges)
In the Reactive Power Control
related the reactive power parameters using the following parameters
groups:
- Watt/Cosphi Settings: Cosphi(P)
- Q Set
- Cosphi Set
- Volt/VAr Settings: Q(V)
Do not change these parameters if not requested by the grid operator.
Digital Outputs
This section of the menu allows you to set the activation status of a relay
This contact can be used, for example, to: activate a siren or a visual
alarm, control the disconnect device of an external transformer, or control
an external device.
- Press
Alarm-Contact (Production)
Alarm-Contact (alarm ALL - no-latch)
Alarm-Contact (crepuscolar)
Alarm-Contact (alarm ALL - latch)
- Click on "AUTO" to activate the relay according to the set operating mode.
Alternatively, the relay can be activated or deactivated manually using the
"ON" and "OFF" buttons
to set the operating mode of the relay. The operating modes are:
- 121 -
7 - Operation
-