Safety Precautions Relating To React2-Batt - ABB REACT 2 Series Product Manual

S
afety precautions relating to REACT2-BATT
Battery System provides a safe source of electrical energy when operated
as intended and as designed.
Potentially hazardous circumstances such as excessive heat or
electrolyte mist may occur under improper operating conditions, damage,
misuse and/or abuse. The following safety precautions and the warning
messages described in this Part must be observed.
HIGH VOLTAGE – ELECTRIC SHOCK HAZARD. Do NOT open any cover of REACT2-BATT
Organic Solvent Electrolyte
Cell components of Battery System contain organic solvent-based
electrolyte. Breach of individual cells may allow some electrolyte to be
released from the cell. Direct contact with the liquid electrolyte can cause
skin irritation.
If contact with the liquid electrolyte occurs, follow the suggestions below
Flush eyes immediately with cold running water for at least 15 minutes.
Rinse skin immediately with water for at least 15 minutes.
Remove clothing if soiled.
Seek immediate medical attention.
Electrolyte Vent Product
Do not incinerate, puncture or impact the Battery System.
Do not solder or weld to the Battery System.
HAZARD. The hazard warnings (set out below) are used to indicate risks or unsafe practices
DO NOT dismantle or disassemble any parts.
DO NOT set light to or heat.
(beyond the temperature range indicated in the technical data).
DO NOT wet with fresh or salt water.
DO NOT create damaging impacts or drop.
DO NOT use for other equipment.
DO NOT touch directly if there is a leak of electrolyte material.
DO NOT touch if it shows any breaks in the cover where any parts
under voltage are visible.
DO NOT use should a fault or any anomaly (such as in smell, heat,
colour, smoke, shape or noise) be found.
3 - Safety and accident prevention
- 46 -