ABB REACT 2 Series Product Manual page 67

connectors:
- To remove the battery signal
08 22
connectors simply pull it.
- To remove the battery power
09 23 press the latch
connectors
( in red) and pull it off.
highlighted
between inverter and battery unit
(supplied inside the REACT2-BATT
box).
Give each cable a pull test to
To execute all external grounding connection, follow the procedure described below:
two cable lugs.
Make a jumper earth cable using the two cable lugs supplied (minimum cross-section not less than 4mm²).
The cable must be long enough to connect the REACT2-BATT external protective earth [B]
REACT2-BATT external protective earth [A]
2. Connect the cable on REACT2-BATT external protective earth [B]
3. Connect the other side of the cable on REACT2-BATT external protective earth [A]
For both connection follow the below installation sequence
Installation sequence:
- knurled washers
- jumper earth cable (other side)
- washers
- M5 nut (torque of 4.1 Nm)
Click
25
24
25
- 67 -
5 - Installation
Click
Click
Click
to the
24
25
24