Procedure For Dismantling Of The React2 System - ABB REACT 2 Series Product Manual

P
rocedure for dismantling of the REACT2 system
Perform the steps for "REACT2 system switch-off", before removing one of the parts making
up the system.
Never open the system parts in the case of humidity >95%.
Always carefully seal all unused openings.
The REACT2 system consists of an inverter unit (REACT2-UNO) and
of a battery unit (REACT2-BATT) which may be dismantled separately.
Even though the device is equipped with an anti-condensation valve,
air with extremely high levels of humidity can lead to the creation of
condensation inside the inverter.
As the inverter is almost completely insulated from the outside,
condensation can also form after maintenance interventions.
To dismantling and disassemble the equipment, refer to the chapters:
Wall installation of the REACT2 system
Wall installation of the REACT2-UNO alone
Follow the indications for the mounting procedure but in the reverse order
- 148 -
8 - Maintenance