Unpacking And Checking; General Handling Information; List Of Components Supplied - ABB REACT 2 Series Product Manual

U
npacking and checking
The packaging components must be disposed of in accordance with the regulations in force in
the country of installation.
G
eneral Handling Information
L
ist of components supplied
Components available for REACT2-UNO
Bear in mind that the packaging elements (cardboard, cellophane,
staples, adhesive tape, straps, etc.) may cause cuts and/or injuries if not
handled with care. They should be removed by suitable means and not
left in the hands of individuals who are not responsible (e.g. children).
When you open the package, check that the equipment is undamaged
and make sure all the components are present.
If any defect or damage is detected, please stop, contact the carrier and
also promptly inform the ABB Service .
When the REACT2-BATT is out of the package, pay attention to:
- Do not short circuit the positive (+) and negative (-).
- Avoid contacting between the metals and the battery unit.
- Do not use seriously scarred or deformed battery unit.
- Do not damage sheath of connectors.
Inside the package the following components required to correctly install
the inverter are supplied
Components supplied together with the inverter REACT2-UNO:
Bracket for REACT2-UNO wall mounting
Connector for connection of the multifunctional relay
Connector for connecting the communication and control signals
protective earth cable installation
- 55 -
4 - Lifting and transport
parallel input channels
Quantity
1
2
1
1 + 1 + 1
1 (red)
+
1 (black)