ABB REACT 2 Series Product Manual page 128

WLAN
In the WLAN sub-menu it's possible to view the status of the two wire-
less channels of the inverter, and to disconnect the channel 2.
Modbus
In the Modbus submenu it is possible to set the RTU inverter commu-
nication mode (RS485):
- type the "Edit" key and select the type of external device
-According to the device, select the communication protocol of the in-
verter
Moreover in the TCP / IP (WLAN / LAN) section there are different
settings based on the type of external device connected to the inverter.
- type the "Edit" key and select the type of external device
- According to the device, select the communication protocol
- type in the [+] key and the added device is displayed
- change the STATE / SLAVE ID / NAME / IP ADDRESS / PORT /
DEVICE settings and save them.
only (Communication protocol server)
Debug Settings
In the Debug Settings sub-menu it's possible to enable or disable the
Debugging access for ABB Service purposes.
- 128 -
7 - Operation