Segger J-Link User Manual page 99

Following remote commands are deprecated and only available for backward compa-
bility:
Remote command
device
interface
speed
Table 3.4: GDB remote commands
Note: The remote commands are case-insensitive.
Note: Optional parameters are set into square brackets.
Note: The examples are described as follows:
Lines starting with
Lines starting with
Lines starting with
J-Link / J-Trace (UM08001)
Select the specified target device.
Note:
instead.
Select the target interface.
Note:
Sets the JTAG speed of J-Link / J-Trace.
Note:
mand line option
are comments and not used in GDB / GDB Server.
'#'
are input commands from the GDB.
'>'
is the output from GDB Server as printed in GDB.
'<'
Explanation
Use command line
Use command line option
For the initial connection speed, use com-
instead.
-speed
© 2004-2017 SEGGER Microcontroller GmbH & Co. KG
99
option
-device
instead.
-if