Segger J-Link User Manual page 237

Syntax
SetMonModeDebug = 0 | 1
Example
SetMonModeDebug = 1
SetMonModeDebug = 0
5.12.1.52 SetResetPulseLen
This command defines the length of the RESET pulse in milliseconds. The default for
the RESET pulse length is 20 milliseconds.
Syntax
SetResetPulseLen = <value>
Example
SetResetPulseLen
5.12.1.53 TraceSampleAdjust
Allows to adjust the sample point for the specified trace data signals inside the J-
Trace firmware. This can be useful to compensate certain delays on the target hard-
ware (e.g. caused by routing etc.).
Syntax
TraceSampleAdjust <PinName> = <Adjust_Ps>[ <PinName>=<Adjust_Ps> ...]
<PinName>
TD
TD0
TD1
TD2
TD3
TD3..0
TD2..1
TDx..y
<Adjust_Ps>
-5000 to 5000
Example
TraceSampleAdjust TD = 1000
5.12.1.54 SetResetType
This command selects the reset strategy which shall be used by J-Link, to reset the
device. The value which is used for this command is analog to the reset type which
shall be selected. For a list of all reset types which are available, please refer to
Reset strategies on page 199. Please note that there different reset strategies for
ARM 7/9 and Cortex-M devices.
Syntax
SetResetType = <value>
Example
SetResetType = 0
J-Link / J-Trace (UM08001)
// Monitor mode debugging is enabled
// Monitor mode debugging is disabled
= 50
Adjust all trace data signals
Adjust trace data 0
Adjust trace data 1
Adjust trace data 2
Adjust trace data 3
Adjust trace data 0-3
Adjust trace data 1-2
Adjust trace data x-y
Adjustment in [ps]
// Selects reset strategy type 0: normal
Description
Description
© 2004-2017 SEGGER Microcontroller GmbH & Co. KG
237