Segger J-Link User Manual page 224

224
Command
map indirectread
map illegal
map ram
map region
map reset
ProjectFile
ReadIntoTraceCache
ScriptFile
SelectTraceSource
SetAllowFlashCache
SetAllowSimulation
SetBatchMode
SetCFIFlash
SetCheckModeAfterRead
SetCompareMode
SetCPUConnectIDCODE
SetDbgPowerDownOnClose
SetETBIsPresent
SetETMIsPresent
SetFlashDLNoRMWThreshol
d
SetFlashDLThreshold
SetIgnoreReadMemErrors
SetIgnoreWriteMemErrors
SetMonModeDebug
TraceSampleAdjust
SetResetPulseLen
SetResetType
SetRestartOnClose
SetRTTAddr
SetRTTTelnetPort
SetRTTSearchRanges
SetRXIDCode
SetSkipProgOnCRCMatch
SetSysPowerDownOnIdle
SetVerifyDownload
SetWorkRAM
ShowControlPanel
SilentUpdateFW
SupplyPower
Table 5.12: Available command strings
J-Link / J-Trace (UM08001)
CHAPTER 5
Specifies an area which should be read indirect.
Marks a specified memory region as an illegal memory
area. Memory accesses to this region are ignored.
Specifies location of target RAM.
Specifies a memory region.
Restores the default mapping, which means all mem-
ory accesses are permitted.
Specifies a file or directory which should be used by
the J-Link DLL to save the current configuration.
Reads the given memory area into the streaming trace
instruction cache.
Set script file path.
Selects which trace source should be used for tracing.
Enables/Disables flash cache usage.
Enables/Disables instruction set simulation.
Enables/Disables batch mode.
Specifies CFI flash area.
Enables/Disables CPSR check after read operations.
Specifies the compare mode to be used.
Specifies an CPU IDCODE that is used to authenticate
the debug probe, when connecting to the CPU.
Used to power-down the debug unit of the target CPU
when the debug session is closed.
Selects if the connected device has an ETB.
Selects if the connected device has an ETM.
Specifies a threshold when writing to flash memory
does not cause a read-modify-write operation.
Set minimum amount of data to be downloaded.
Specifies if read memory errors will be ignored.
Specifies if write memory errors will be ignored.
Enables/Disables monitor mode debugging.
Allows to adjust the sampling timing on the specified
pins, inside the J-Trace firmware
Defines the length of the RESET pulse in milliseconds.
Selects the reset strategy.
Specifies restart behavior on close.
Set address of the RTT buffer.
Set the port used for RTT telnet.
Set ranges to be searched for RTT buffer.
Specifies an ID Code for Renesas RX devices to be
used by the J-Link DLL.
Specifies the CRC match / compare mode to be used.
Deprecated, use
SetCompareMode
Used to power-down the target CPU, when there are
no transmissions between J-Link and target CPU, for a
specified timeframe.
Specifies the verify option to be used.
Specifies RAM area to be used by the J-Link DLL.
Opens control panel.
Update new firmware automatically.
Activates/Deactivates power supply over pin 19 of the
JTAG connector.
© 2004-2017 SEGGER Microcontroller GmbH & Co. KG
Working with J-Link and J-Trace
Description
instead.