Command Line Interface - Segger J-Link User Manual

11.5 Command Line Interface

This chapter describes the J-Flash SPI command line interface. The command line
allows using J-Flash SPI in batch processing mode and other advanced uses.
11.5.1 Overview
In addition to its traditional Windows graphical user interface (GUI), J-Flash SPI sup-
ports a command line mode as well. This makes it possible to use J-Flash SPI for
batch processing purposes. All important options accessible from the menus are
available in command line mode as well. If you provide command line options, J-
Flash SPI will still start its GUI, but processing will start immediately.
The screenshot below shows the command line help dialog, which is displayed if you
start J-Flash SPI in a console window with JFlashSPI.exe -help or JFlashSPI.exe
-?
11.5.2 Command line options
This section lists and describes all available command line options. Some options
accept additional parameters which are enclosed in angle brackets, e.g. <FILE-
NAME>. If these parameters are optional they are enclosed in square brackets too,
e.g. [<SADDR>]. Neither the angel nor the square brackets must be typed on the
command line, they are used here only to denote (optional) parameters. Also, note
that a parameter must follow immediately after the option,
e.g. JFlashSPI.exe -openprjC:\Projects\Default.jflash.
J-Link / J-Trace (UM08001) © 2004-2017 SEGGER Microcontroller GmbH & Co. KG
311