Segger J-Link User Manual page 239

SetRXIDCode = 112233445566778899AABBCCDDEEFF00
5.12.1.60SetSkipProgOnCRCMatch
Note: Deprecated. Use
This command is used to configure the CRC match / compare mode.
Syntax
SetSkipProgOnCRCMatch = <CompareMode>
Compare mode
0
1
2
3
Example
SetSkipProgOnCRCMatch = 1
5.12.1.61 SetSysPowerDownOnIdle
When using this command, the target CPU is powered-down when no transmission
between J-Link and the target CPU was performed for a specific time. When the next
command is given, the CPU is powered-up.
Note: This command works only for Cortex-M3 devices.
Typical applications
This feature is useful to reduce the power consumption of the CPU.
Syntax
SetSysPowerDownOnIdle = <value>
Note: A 0 for <value> disables the power-down on idle functionality.
Example
SetSysPowerDownOnIdle = 10; // The target CPU is powered-down when there is no
10ms
5.12.1.62SetVerifyDownload
This command is used to configure the verify mode.
Syntax
SetVerifyDownload = <VerifyMode>
Verify mode
0
1
2
3
4
5
6
7
8
J-Link / J-Trace (UM08001)
SetCompareMode
Skip
Using fastest method (default)
Using CRC
Using readback
// Select using fastest method
// transmission between J-Link and target CPU for at least
Skip
Programmed sectors, fastest method (default)
Programmed sectors using CRC
Programmed sectors using readback
All sectors using fastest method
All sectors using CRC
All sectors using read back
Programmed sectors using checksum
All sectors using checksum
© 2004-2017 SEGGER Microcontroller GmbH & Co. KG
instead.
Description
Description
239